Aspen Touch Solutions SW601532 manual General Mounting Information, Rear Vesa Mount

Page 8

Chapter 3 – Mounting

General Mounting Information

The OSD text can be rotated through the OSD menu to better suit your mounting orientation.

The holes located on the sides and top of the touchmonitor case are for ventilation. Do not block, cover, or insert anything inside the ventilation slots.

Rear VESA Mount

A four-hole 75x75mm mounting pattern for M4 screws is provided on the rear of the monitor. Remove the stand using a Phillips screwdriver to access this mounting interface. The VESA FDMI-compliant counting is coded: VESA MIS-B, 75, C

User Manual – 1509L

SW601532 Rev A - Page 8 of 18

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Elo TouchSystems 1509L Touchmonitor Disclaimer Trademark Acknowledgments Table of Contents Product Description PrecautionsIntroduction Installation Connector Panel & Interfaces Touchmonitor ConnectionsInstalling the Touch Technology Software Drivers Unpacking the TouchmonitorSW601532 Rev a Page 6 SW601532 Rev a Page 7 Rear Vesa Mount MountingGeneral Mounting Information Power OperationTouch VideoPhase On-Screen Display OSDOSD and Power Lockouts Aspect RatioTechnical Assistance Solutions to Common ProblemsTechnical Support Safety & Maintenance SafetyCare and Handling Waste Electrical & Electronic Equipment Directive WeeeRegulatory Information PBB SW601532 Rev a Page 16 Warranty Information Check out Our Website
Top Page Image Contents