Intec AVT-597 guide

Removable (Quick-Release) mounting of the E-Z FIT floor console. (Requires optional Quick-Release Kit: Part Number 0892125)

The E-Z FIT console can be mounted with optional brackets that allow the console to be easily removed from the vehicle for in-home use or in-hotel use when traveling. This kit contains four (4) U-shaped brackets that permanently mount to the floor of the vehicle. (Also included in the kit are eight (8) bolts, eight (8) fender washers and eight (8) locking nuts.) The E-Z FIT console mounts to these brackets and is fastened down with thumbscrews (See Figure 2 below)

•Attach the four (4) U-shaped brackets to the four (4) feet of the E-Z FIT console using the thumbscrews. Make sure that the brackets are perpendicular to the feet of the console. (See Figure 2 below.)

Figure 2

•Set the console on the floor of the vehicle and mark where the eight (8) holes of the U-shaped brackets are to be drilled. (Make sure that you have checked under the vehicle and in the vehicle floor (under the carpet) for obstructions)

•Remove the console from the vehicle.

•Using the utility knife, score the carpet over the marks with an ‘X’ so that the drill bit does not ‘grab’ and unravel the carpet.

•Drill eight small 1/8” pilot holes to verify that the holes are in the proper locations.

•After verifying that the 1/8” pilot holes are in the proper locations, use the ¼” drill bit to enlarge the pilot holes.

•Set the console on the floor over the holes.

•Place the bolts through the brackets (attached to the feet of the console) and into the holes just drilled.

•Place one large fender washer over each of the bolts and attach the nuts. (Note: It may be desirable to place a small circle of silicon sealer around the hole under the vehicle before installing the washer and nut to prevent moisture from getting into the vehicle.)

•Tighten the nuts down securely. Have the second person inside the vehicle hold the bolts securely with the box-end wrench while the person underneath the vehicle tightens down the nuts. See Figure 3 below.

•Plug the cigarette lighter cord into the jack on the console (by driver’s seat). Plug the other end into the cigarette lighter receptacle.