Using the Remote Control:
Refer to the section “Remote Control Operation” in your AVT597 owners manual.
Troubleshooting Hints and Tips: | ||
TV or VCP do not turn on: | Make sure that the cigarette lighter cord is plugged into the cigarette lighter | |
|
| and the base of the console. |
|
|
|
|
| Some vehicles do not apply power to the cigarette lighter when the ignition is |
|
| turned off. Try turning the ignition switch to the ON or ACC position. |
|
| Check to see if there is power at the cigarette lighter plug. The fuse may be |
|
| blown in the fuse panel. Replace the fuse and test the system. (IMPORTANT: |
|
| Make sure the condition that caused the fuse to blow has been corrected |
|
| before replacing the fuse). |
|
| The fuses in the TV or VCP may be blown. To check these fuses, the front |
|
| bezel of the console needs to be removed. Remove the six screws that hold |
|
| the bezel of the console on and remove the bezel. Slide the TV out and check |
|
| the fuse on the back. Slide the VCP out and check the fuse on the back. |
|
| Replace these fuses if necessary. (IMPORTANT: Make sure the condition that |
|
| caused these fuses to blow has been corrected before replacing these fuses). |
|
| Replace the front bezel and screws. |
|
|
|
No picture when playing a tape: | Make sure that the TV is turned on. | |
|
| Check to see that the TV is not in video mode. Press the TV/Video switch to |
|
| change between TV and Video modes. |
|
| Make sure the brightness control is up. |
|
|
|
No picture when playing a camcorder: | Make sure that the TV is turned on. | |
|
| Make sure that the camcorder is properly plugged into the Audio/Video jacks. |
|
|
|
|
| Check to see that the TV is in video mode. Press the TV/Video switch to |
|
| change between TV and Video modes. |
|
| Make sure the brightness control is up. |
Remote Control not working: | Check that the Remote is pointed at the TV or VCP. | |
|
|
|
|
| Check the batteries and replace if they are worn out. |
|
|
|