English

CPress the Auto Set-up Button.

DAdjust the image manually by following procedure below when the screen has a flicker or blur, or the picture does not fit in the display area after performing the Auto Set-up.

EStretch the right side of the picture frame to the right edge of the display area by adjusting the Clock.

FAdjust the Phase to correct horizontal wavy noise, flicker or blur in the zebra pattern.

GSelect “Position” in the Adjustment Program and adjust the H-Position and V-Position s o that the frame of the cross-hatch pattern fits into the display area.

NOTE

n When the left side of the picture frame moves away from the left edge of the display area during the Clock adjustment, adjust Clock and H-Position alternately.

n Another way to make the Clock adjustment is to correct the vertical wavy lines in the zebra pattern.

n The picture may flicker during the Clock, H-Position and V-Position adjustment.

nIn case the picture frame is bigger or smaller than the data display area after the Clock adjustment, repeat steps from C.

nIn the case that a strong flicker or blurs remain on a part of the screen, repeat the adjustments from E to readjust the Clock. If the flicker or blurs still remain then set the refresh rate to 60Hz and repeat the adjustments from step C.

nAdjust the H-Position after the Phase adjustment if the horizontal position moves during the adjustment.

OPERATING THE MONITOR 23