Elo TouchSystems 3243L/3209L user manual SW200146 Rev A, Page 24

Page 24

Directives and Standards: This equipment has been tested to the requirements for the CE Mark

as required by EMC Directive 2004/108/EC as indicated in European Standard EN 55022 Class B and the Low Voltage Directive 2006/95/EC as indicated in European Standard EN 60950.

General Information to all Users: This equipment generates, uses and can radiate radio frequency energy. If not installed and used according to this manual the equipment may cause interference with radio and television communications. There is, however, no guarantee that interference will not occur in any particular installation due to site-specific factors.

1)In order to meet emission and immunity requirements, the user must observe the following:

a)Use only the provided I/O cables to connect this digital device with any computer.

b)To ensure compliance, use only the provided manufacturer’s approved line cord.

c)The user is cautioned that changes or modifications to the equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

2)If this equipment appears to cause interference with radio or television reception, or any other device:

a)Verify as an emission source by turning the equipment off and on.

If you determine that this equipment is causing the interference, try to correct the interference by using one or more of the following measures:

i)Move the digital device away from the affected receiver.

ii)Reposition (turn) the digital device with respect to the affected receiver.

iii)Reorient the affected receiver’s antenna.

iv)Plug the digital device into a different AC outlet so the digital device and the receiver are on different branch circuits.

v)Disconnect and remove any I/O cables that the digital device does not use.(Unterminated I/O cables are a potential source of high RF emission levels.)

vi)Plug the digital device into only a grounded outlet receptacle. Do not use AC adapter plugs. (Removing or cutting the line cord ground may in crease RF emission levels and may also present a lethal shock hazard to the user.)

User Manual: 3243L/3209L

SW200146 Rev A, Page 24 of 28

Image 24
Contents Elo Touch Solutions 3243L/3209L Touchmonitors Copyright 2012 Elo Touch Solutions, Inc. All Rights Reserved Table of Contents Precautions IntroductionProduct Description Installation Unpacking the TouchmonitorConnector Panel & Interfaces Touchmonitor Connections Installing the Touch Technology Software Drivers SW200146 Rev A, Page 8 SW200146 Rev A, Page 9 Mounting General Mounting InformationSide Bracket Mount 3243L Only Rear Vesa Mount Page Power OperationTouch IntelliTouch Plus Touchscreen TechnologySW200146 Rev A, Page 14 Gesture Support Video On-Screen Display OSDParameter Available Adjustment Brightness OSD OSD and Power Lockouts Solutions to Common Problems Technical SupportTechnical Assistance Safety & Maintenance SafetyCare and Handling Waste Electrical & Electronic Equipment Directive Weee Electrical Safety Information Regulatory InformationII. Emissions and Immunity Information SW200146 Rev A, Page 24 III. Agency Certifications IV. China RoHSSW200146 Rev A, Page 26 Warranty Information Getting in Touch with us Check out Our Website