Elo TouchSystems 2740L user manual Regulatory Information, Electrical Safety Information

Page 22

Chapter 7: Regulatory Information

I. Electrical Safety Information:

Compliance is required with respect to the voltage, frequency, and current requirements indicated on the manufacturer’s label. Connection to a different power source than those specified herein will likely result in improper operation, damage to the equipment or pose a fire hazard if the limitations are not followed.

There are no operator serviceable parts inside this equipment. There are hazardous voltages generated by this equipment which constitute a safety hazard. Service should be provided only by a qualified service technician.

Contact a qualified electrician or the manufacturer if there are questions about the installation prior to connecting the equipment to mains power.

II. Emissions and Immunity Information

Notice to Users in the United States: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

Notice to Users in Canada: This equipment complies with the Class B limits for radio noise emissions from digital apparatus as established by the Radio Interference Regulations of Industrial Canada.

Notice to Users in the European Union: Use only the provided power cords and interconnecting cabling provided with the equipment. Substitution of provided cords and cabling may compromise electrical safety or CE Mark Certification for emissions or immunity as required by the following standards:

This Information Technology Equipment (ITE) is required to have a CE Mark on the Manufacturer’s label which means that the equipment has been tested to the following Directives and Standards: This equipment has been tested to the requirements for the CE Mark

User Manual: 2740L

SW602096 Rev A, Page 22 of 27

Image 22
Contents Elo Touch Solutions 2740L Touchmonitors Copyright 2013 Elo Touch Solutions, Inc. All Rights Reserved Table of Contents Introduction PrecautionsProduct Description Installation Unpacking the TouchmonitorConnector Panel & Interfaces Touchmonitor Connections Installing the Touch Technology Software Drivers SW602096 Rev A, Page 8 SW602096 Rev A, Page 9 Side Bracket Mount MountingGeneral Mounting Information Rear Vesa MountSW602096 Rev A, Page 11 Touch PowerOperation IntelliTouch Plus Touchscreen TechnologySW602096 Rev A, Page 13 Gesture Support Video On-Screen Display OSDParameter Available Adjustment Brightness OSD OSD and Power Lockouts Solutions to Common Problems Technical SupportTechnical Assistance Safety Safety & MaintenanceCare and Handling Waste Electrical & Electronic Equipment Directive Weee Regulatory Information Electrical Safety InformationII. Emissions and Immunity Information SW602096 Rev A, Page 23 III. Agency Certifications IV. China RoHSSW602096 Rev A, Page 25 Warranty Information Getting in Touch with us Check out Our Website