Elo TouchSystems 2740L user manual Connector Panel & Interfaces Touchmonitor Connections

Page 6

Connector Panel & Interfaces

Touchmonitor Connections

1.Connect the DVI or VGA video cables between the monitor’s DVI/VGA input connectors and your DVI/VGA video source. Tighten the video cable’s screws for best performance.

2.Connect the USB touch cable between the monitor’s USB connector and your PC’s USB port. (Not applicable for ET2740L-0NXX models)

3.Connect a 12VDC power supply to the monitor’s input power jack.

4.The touchmonitor ships in an ON state, video should be displayed on your monitor already.

User Manual: 2740L

SW602096 Rev A, Page 6 of 27

Image 6

Contents Elo Touch Solutions 2740L Touchmonitors Copyright 2013 Elo Touch Solutions, Inc. All Rights Reserved Table of Contents Precautions IntroductionProduct Description Installation Unpacking the TouchmonitorConnector Panel & Interfaces Touchmonitor Connections Installing the Touch Technology Software Drivers SW602096 Rev A, Page 8 SW602096 Rev A, Page 9 Side Bracket Mount MountingGeneral Mounting Information Rear Vesa MountSW602096 Rev A, Page 11 Touch PowerOperation IntelliTouch Plus Touchscreen TechnologySW602096 Rev A, Page 13 Gesture Support Video On-Screen Display OSDParameter Available Adjustment Brightness OSD OSD and Power Lockouts Solutions to Common Problems Technical SupportTechnical Assistance Safety & Maintenance SafetyCare and Handling Waste Electrical & Electronic Equipment Directive Weee Electrical Safety Information Regulatory InformationII. Emissions and Immunity Information SW602096 Rev A, Page 23 III. Agency Certifications IV. China RoHSSW602096 Rev A, Page 25 Warranty Information Getting in Touch with us Check out Our Website