Elo TouchSystems 3243L user manual Connector Panel & Interfaces Touchmonitor Connections

Page 6

Connector Panel & Interfaces

Touchmonitor Connections

1.Connect the HDMI, DVI, or VGA video cables between the monitor’s HDMI/DVI/VGA input connectors and your HDMI/DVI/VGA video source. Tighten the video cable’s screws for best performance.

2.Connect the USB touch cable between the monitor’s USB connector and your PC’s USB port. (Not applicable for ET3243L-0NXX models)

3.Connect the power cable to the monitor’s input power jack and the AC power outlet.

4.The touchmonitor ships in an ON state, video should be displayed on your monitor already.

User Manual: 3243L

SW601960 Rev A, Page 6 of 26

Image 6

Contents Elo Touch Solutions 3243L Touchmonitors Copyright 2012 Elo Touch Solutions, Inc. All Rights Reserved Table of Contents Precautions IntroductionProduct Description Installation Unpacking the TouchmonitorConnector Panel & Interfaces Touchmonitor Connections Installing the Touch Technology Software Drivers SW601960 Rev A, Page 8 SW601960 Rev A, Page 9 Mounting General Mounting InformationSide Bracket Mount Rear Vesa Mount Touch PowerOperation IntelliTouch Plus Touchscreen TechnologyGesture Support Video On-Screen Display OSDParameter Available Adjustment Brightness OSD and Power Lockouts ColorSolutions to Common Problems Technical SupportTechnical Assistance Safety & Maintenance SafetyCare and Handling Waste Electrical & Electronic Equipment Directive Weee Electrical Safety Information Regulatory InformationII. Emissions and Immunity Information SW601960 Rev A, Page 22 III. Agency Certifications IV. China RoHSSW601960 Rev A, Page 24 Warranty Information Getting in Touch with us Check out Our Website