Hanns.G HN Series user manual Adjusting the Viewing Angle, Figure.3. monitor’s angle

Page 12

User’s Manual

ADJUSTING THE VIEWING ANGLE

For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’s angle to your own preference.

Hold the stand so you do not topple the monitor when you change the monitor’s angle.

You are able to adjust the monitor’s angle from 0° to 20°.

Figure.3. monitor’s angle

NOTES:

Do not touch the LCD screen when you change the angle. It may cause damage or break the LCD screen.

Be careful not to place fingers or hands near the hinges when tilting the monitor, otherwise pinching can result.

12

Image 12
Contents Inch HN Series TFT LCD Monitor FCC Class B Radio Frequency Interference Statement Congratulations ErgonomicsEnergy EmissionsRecycling Information Europe Ireland Contact Person Ms. McGrath ClodaghTable of Contents Safety Notice PrecautionsSpecial Notes on LCD Monitors Features Checking the Contents of the PackageBefore YOU Operate the Monitor Installation Instructions InstallInstallation RemovalPower Power SourceControls and Connectors Cable ConnectionsAdjusting the Viewing Angle Figure.3. monitor’s angleOperating Instructions General InstructionsPower Button Power IndicatorVolume Auto Adjust buttonHOW to Adjust a Setting OSD Diagram OSD Description Brightness/Contrast adjustmentImage Control ColorPlug and Play OtherUser’s Manual Technical Support FAQ For General DefectiveError Message & Possible Solution Factory Preset Timing TableSpecifications AppendixConnector PIN Assignment ƒ 24 Pin Color Display Signal Cable Dual Input Mode