II. Preparation of Console for Installation

7"T

-~~:i"~tC ~ ~5rf:;.","

~",,~' ,~~

FIGURE4

9.Install rear mounting bracket (item 6 pg 2) and secure using (4) four # 8 x 3,{" screws (item 2 pg 2). Make sure that holes in bracket align with dimples in roof brace. See figure 5.

8.Carefully trim headliner and drill (2) two Y2" holes in return air grille to allow for screws to pass through when mounting bracket. See fig. 4.

'--"-

FIGURE 5

II. PREPARATION OF CONSOLE FOR INSTALLATION

~ .f

f ii ;:

L W

~ ~

10.Install the video system in console and secure using hardware supplied with video system. Start all screwsbefore tightening. Be~n with the rear center screw, then alternately tighten screws around the perimeter of pod. Seefigure

6.Refer to owner's manual supplied with video system. Caution: Do not overtighten

~, I

screws.

FIGURE6