Dodge 118127X manual III. Installa Tion of Console

III. INSTALLA TION OF CONSOLE

"" " .

NOTE: Additional a"ssistance in mounting the overhead console in vehicle is

advised to prevent damage to console or components. c

13. Install and route all accessory wiring, video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to B-pillar. Down the B-pillar to the floor. Route the power lead to an accessory controlled source. Connect the ground lead to the vehicle chassis. Route the remaining wiring (RCA plugs, Remote Sensor extension, etc.) to the VCP location. See figure 12. Connect per instructions included with the video system. Ifvideo system if to be used as a television, install an

f

~

:;:

...

~

'.

~

~

rf

~-

J

;t

~

r. t

f

appropriate antenna per instructions included

with the antenna.

Figure 12

	14. Raise console into approximate position and
	connect all wiring to components.Connect
	wiring aI)d cabling to video system per
	instructions included with \'ideo system.
	15. Check function of all componentsand lights.
	Seeoperating instructions for video system
	operations check. For further assistance,refer
	to the video systemmanual for the technical
	support phone number listed for your area.
	16. Carefully position console againstheadliner.
	Releasevideo screenfrom locked position.
	Lower video screento viewing position for
	accessto mounting locations in top of video
	systemhousing and align holes in housing
	with holes in rear mounting bracket. Secure
	using (4) four # 6 x Y2"screws(item 1 pg 2).
Figure 13	Seefigure 13.

0; ii

.

"'

Caution: Do not overtighten screws. Use extra support for the console until secured to the vehicle. Failure to do so may cause damage to console or installed components.