Boss Audio Systems 815ca manual DIN REAR-MOUNT Method B

Removing the unit

a

b

c

a.Frame

b.Insert fingers into the groove in the front of frame and pull out to remove the frame. (When re-attaching the frame, point the side with a groove down wards and attach it.)

c.Insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click. Pulling the levers makes it possible to remove the unit from the dashboard.

-Trim Plate Installation:

Before attaching the trim plate, the side with a "Bottom" Label stuck should be at down side (as shown on diagram).

Push the trim plate against the main panel until it is fitted.

OM BOTT

-DIN REAR-MOUNT (METHOD B)

Installation using the screw holes on the sides of the unit. Fastening the unit to the factory radio mounting bracket.

1.Select a position where the screw holes of the bracket and the screw holes of the main unit become aligned (are fitted) and tighten the

2			screws at 2 places on each side.
		2.	Screw
	4	3.	Factory radio mounting bracket.
		4.	Dashboard or Console
5		5.	Hook (Remove this part)
		Note: The mounting box, outer trim ring,
3
		and half-sleeve are not used for method

2 B installation.

5

-PANEL OPEN / CLOSE OPERATION

1

	D	IN
2
	C

1.Press Open button

2.The CD slot will be accessible.

3.After CD is loaded or unloaded return the panel to its original position.

Note: Before inserting or ejecting disc, press the Release button to flip down the faceplate.

Open button

E - 3