Antenna Motor Trigger Switch

each have at least 8 ohms impedance.

•DON’T connect the left and right speaker leads to each other or to the same speakers.

•DON’T connect the front and rear speaker leads to each other or to the same speakers.

•DON’T connect the negative speaker leads to each other.

•DON’T connect the positive speaker leads to each other.

•DON’T connect any active speakers (with built-in amplifiers) to the speaker leads unless their owner’s manuals specifically state that this is O.K.

•Cover the ends of any unused leads with electrical tape. This will prevent them from touching the vehicle or each other and causing a short-circuit and damage to the receiver or vehicle.

Connecting the Pre-Amp Outputs to External Amplifier(s)

To prevent short circuits or serious damage to the receiver, amplifier, and/or speakers:

•Follow the amplifier’s instructions on how to connect the unit’s preamp outputs to the amplifier(s) and connect the speaker(s) directly to the amplifier.

* SWITCH

Harness has single blue lead that can be used for either antenna motor trigger or amp trigger or spliced for

use with both. (See note 3.)