Blaupunkt MP41 Troubleshooting Guide, MP3 File Play Troubleshooting, CD Player Troubleshooting

Troubleshooting Guide

	The following check will assist in the correction of most prob-
	lems which you may encounter with your unit. Before going
ENGLISH	through the check list below, refer back to the connection and
	operating procedures.

MP3 File Play Troubleshooting

TroubleCause/Solution

CD Player Troubleshooting

When problems occur with CD playback, an error message appears in the display window.

General

	Trouble	Cause/Solution
•	Memorized stations and	Leads are not matched
	correct time are erased.	correctly with the car’s
•	The fuse has blown.	accessory power
•	Radio works when the igni-	connector.
	tion key is the ON, ACC and	Check wiring for short
	OFF positions.	circuits.

MP3 Files cannot be played.

•Write MP3 files with the extension “.mp3” to disc.

•Ensure that files other than MP3 files do not have the extension “.mp3”.

•Use discs conforming to ISO9660 level 1/2.

•Confirm that the disc is not scratched or dirty, and that it is not upside down.

Refer to the table below to identify the problem, then take the suggested corrective action. If the “SLED ERROR” appears, return unit to your nearest Blaupunkt dealer.

Message	Possible cause	Recommended action
LD/EJ ERROR Loading/eject error. Press the EJECT
		button and then
		reinsert the disc.
SERVO ERROR Mechanical error.		Eject and then reinsert

•	No power is being supplied
	to the unit.
•	The power is continuously	The car doesn't have an
	supplied to the unit.	ACC position.

Radio reception

Trouble Cause/Solution

Folder Name/File Name is not cor- rectly displayed.

•Use a disc conforming to ISO9660 level 1/2.

•The name contains characters that could not be handled by the software used to write the files. Refer to the instruction manual for the software and use only characters that can be handled by the software.

		the disc.
TOC ERROR	The disc is dirty,	Check the disc and
	reversed or not	replace with a proper
	recorded etc.	disc.
FILE ERROR	File read failure.	Reinsert the disc.
		The disc does not contain
		music files or the file
		extensions are missing.

Preset stations are not receiv-	The broadcast signal is too
able.	weak.
Seek tuning is not possible.	The broadcast signal is
	too weak. → Use manual
	tuning.
Travel Store feature does not	Not enough broadcast fre-

ID3-Tag is not dis-	• Record conforming with ID3-Tag
played.	v1.0/1.1/2.2 or 2.3.
Time elapses be-	• As this unit initially checks all files
fore an MP3 file is	on the disc, some time may be re-
played.	quired before it can start playing a
	file if the disc contains many files or
	folders or many folder levels.

Add the extension “.mp3”

or “.wma”.

COMM ERROR Communication Reinsert the disc.

error.

• When the disc can not be inserted, press the EJECT button

complete storing of six sta-	quencies are receivable.
tions.

Also make sure that antenna is connected, extended and dry inside.

If the above mentioned solutions do not help to improve the situation, consult your nearest Blaupunkt dealer or in the United States call 1-800-266-2528 for technical assistance, parts and service. Call 1-800-950-2528 for dealer referral or to request product brochure.

MP3 files are not played in order.

•The files were not written by the write software in the desired playback or- der.

Prefix digits such as “00”...”99" to the file names. For details refer to the in- struction manual for the write soft- ware.

	(See page 2.) and try inserting the disc again. Alternatively,
	press the Reset button (See page 21.) and try inserting the
	disc again.
•	If the disc does not eject after the EJECT button is pressed,
	press the Reset button and then press the EJECT button
	again.
•	CD-R/RW: Quality of the blanks can & do effect the general
	operation of the CD player.
•	After market CD-R/RW labels: The quality of these labels
	vary greatly, and can result in difficulties ejecting a disc us-
	ing such labels.

E-22