Troubleshooting Guide
The following check will assist in the correction of most prob- lems which you may encounter with your unit. Before going through the check list below, refer back to the connection and operating procedures.
MP3 File Play Troubleshooting
TroubleCause/Solution
CD Player Troubleshooting |
When problems occur with CD playback, an error message |
appears in the display window. |
General
Trouble | Cause/Solution |
• Memorized stations and | Leads are not matched |
correct time are erased. | correctly with the car’s |
• The fuse has blown. | accessory power |
• Radio works when the igni- | connector. |
tion key is the ON, ACC and | Check wiring for short |
OFF positions. | circuits. |
MP3 Files cannot be played.
•Write MP3 files with the extension “.mp3” to disc.
•Ensure that files other than MP3 files do not have the extension “.mp3”.
•Use discs conforming to ISO9660 level 1/2.
•Confirm that the disc is not scratched or dirty, and that it is not upside down.
Refer to the table below to identify the problem, then take the | ENGLISH | ||
suggested corrective action. If the “SLED ERROR” appears, | |||
return unit to your nearest Blaupunkt dealer. | |||
|
|
| |
Message | Possible cause | Recommended action |
|
LD/EJ ERROR Loading/eject error. Press the EJECT |
| ||
|
| button and then |
|
|
| reinsert the disc. |
|
SERVO ERROR Mechanical error. | Eject and then reinsert |
| |
• | No power is being supplied |
|
| to the unit. |
|
• | The power is continuously | The car doesn't have an |
| supplied to the unit. | ACC position. |
Radio reception
Trouble | Cause/Solution |
Folder Name/File Name is not cor- rectly displayed.
•Use a disc conforming to ISO9660 level 1/2.
•The name contains characters that could not be handled by the software used to write the files. Refer to the instruction manual for the software and use only characters that can be handled by the software.
the disc. |
TOC ERROR | The disc is dirty, | Check the disc and |
| reversed or not | replace with a proper |
| recorded etc. | disc. |
FILE ERROR | File read failure. | Reinsert the disc. |
|
| The disc does not contain |
|
| music files or the file |
|
| extensions are missing. |
Preset stations are not receiv- | The broadcast signal is too |
able. | weak. |
Seek tuning is not possible. | The broadcast signal is |
| too weak. → Use manual |
| tuning. |
Travel Store feature does not | Not enough broadcast fre- |
• Record conforming with | |
played. | v1.0/1.1/2.2 or 2.3. |
|
|
Time elapses be- | • As this unit initially checks all files |
fore an MP3 file is | on the disc, some time may be re- |
played. | quired before it can start playing a |
| file if the disc contains many files or |
| folders or many folder levels. |
|
|
|
|
Add the extension “.mp3” |
or “.wma”. |
COMM ERROR Communication Reinsert the disc. |
error. |
• When the disc can not be inserted, press the EJECT button |
complete storing of six sta- | quencies are receivable. |
tions. |
|
Also make sure that antenna is connected, extended and dry inside.
If the above mentioned solutions do not help to improve the situation, consult your nearest Blaupunkt dealer or in the United States call
MP3 files are not played in order.
•The files were not written by the write software in the desired playback or- der.
Prefix digits such as “00”...”99" to the file names. For details refer to the in- struction manual for the write soft- ware.
| (See page 2.) and try inserting the disc again. Alternatively, |
| press the Reset button (See page 18.) and try inserting the |
| disc again. |
• If the disc does not eject after the EJECT button is pressed, | |
| press the Reset button and then press the EJECT button |
| again. |
• | |
| operation of the CD player. |
• | After market |
| vary greatly, and can result in difficulties ejecting a disc us- |
| ing such labels. |
MP3000_body_en | 19 | 9/4/01, 4:25 PM |