Blaupunkt ACD 9430 Anti-theft coding, Installation/connection, Wrong code number entered

Page 5
This waiting time is 10 seconds after the first three attempts, and 1 hour following subse- quent attempts.
If the power supply to the radio is interrupted while the code system is switched on, you need to know the right code number.
The radio will operate again as soon as you have entered the right code number.
If you lose your radio passport and have forgotten your code number, you will not be able to restart the set after the power supply has been interrupted. In this case, your radio can only be reset in our central customer service workshop or in one of our service agencies abroad.
Switching the code system on Precondition:

 

Anti-theft coding

To listen to the radio or cassette again,

The car radio comes standard with the code

• insert the set into the compartment until

system deactivated.

it stops and move the handle back to

If the anti-theft coding system is on while the

the front panel.

power supply to the unit is interrupted (e.g.

If the coding system is off, your set will be

theft, disconnecting the car battery), the set is

ready for operation.

electronically blocked. Then it may only be

If the coding system is on, proceed as des-

used again after the appropriate code num-

cribed under “Restart following interruption

ber has been entered (see car radio pass-

of power supply”.

port).

Installation/connection

The code system can only be switched on and off, if the radio is connected to perma- nent power.

If you like to install your new car radio by yourself or add other audio components to the existing ones, then please read carefully the enclosed instructions on installation and

Wrong code number entered

It should not be possible for thieves to ascer- tain the code number by trial-and-error. This is why the set will be blocked for a certain period of time, if an incorrect code number is

entered. In this case, “- - -” will appear in the The radio must be connected to permanent

display.

power.

 

In order to switch the code system on:

connection.

Do not connect the loudspeaker outputs to ground!

Only use the accessory and replacement parts approved by Blaupunkt.

After 19 unsuccessful attempts, “OFF” will appear in the display and the set can no

longer be restarted.

 

Note:

 

Turn the radio off.

Hold down the preset buttons 1 and 4 simultaneously.

Turn the radio on.

“Cod” briefly appears before the radio begins to operate.

Keep you car radio passport with the code number in a safe place in order to avoid “unauthorized access” to your car radio.

Release preset buttons 1 and 4. The code system is on.

“Cod” will be briefly displayed each time the radio is turned on.

14

Image 5
Contents ACD Radio a b c d Front Panel Description Important information ContentsWrong code number entered Installation/connectionAnti-theft coding Switching the code system off Power supplyAmplifier Section Restart following interruptionRadio Section Automatically Storing the Stron- gest Stations Memorizing a StationActivating a Stored Station Traffic Messages ARICD Section What to Do If Your Car Stereo Needs Service? Technical DataAdjusting the seek tuning sensitivity Programming with DSC Appendix