Radio Section

Balance and Fader Control

Balance control

To balance the sound level left/right:

•Press the AUD button 2 until bal is

shown on the display.

Press rocker switch < > 7 on the left or right to adjust the sound impression

according to your personal preferences. Display 9 gives you a number bet- ween -9 and +9.

Fader control

To balance the front/rear sound level:

•Press the AUD button 2 until fad is

shown on the display.

Press rocker switch < > 7 on the left or right to adjust the sound impression

according to your personal preferences. Display 9 gives you a number bet- ween -9 and +9.

Note:

If the rocker switch < > is kept depressed (on the left or right), the set quickly advances to the final values (+7/+9 or -7/-9) or to the “0” position.

Selecting the Desired Waveband

With this set you have free choice from the following wavebands:

FM (ultra-short wave; frequency-modulated), MW (medium wave), and LW (long wave).

Selecting FM

•Press the FM•T button 3 briefly. “FM” lights up on display 9a.

Selecting MW or LW

•Press the M•L button 4 briefly. Either “MW” (for medium wave frequencies) or

“LW” (for long wave frequencies) lights up on display 9 g, c.

For changing between MW and LW:

•Press the M•L button 4 once again.

Tuning in a Station Automatical- ly

Tuning in the following station

•Press the < > rocker switch 7 on the right. The car stereo automatically starts searching for the next station.

Tuning in the previous station

•Press the < > rocker switch 7 on the left. The car stereo automatically starts searching for the previous station.

If the < > rocker switch 7 is kept de- pressed on the right or the left, the sta- tion seek operation continues to be carried out quickly in the corresponding direction.

Manual Tuning

To manually tune in a station,

•press the lo•m button 5 until “m” lights up on display 9 f.

You can now manually search for the desired stations via the < > buttons 7.

Adjusting the Station Seek Sensitivity

With this set you can modify the automatic station seek sensitivity in all wavebands.

If you want to search for strong stations only (reduced sensitivity):

•Press the lo button 5 until “lo” lights up on display 9 e.

If you also want to search for weaker stations (increased sensitivity):

•Press the lo button 5 once again; the “lo” indication on display 9e goes out.