Blaupunkt ACM 5450 Changing the memory bank, Selecting a station, Storing stations

If you leave the service area of the regional programme tuned into, or if you would like to take advantage of the full RDS service, switch to “REG OFF”.

•Press the AF button for approximately 2 seconds until “REG OFF” appears.

Manual tuning	Each time the radio is switched on, stereo
Prerequisite: “m” lights	up in the display. playback is activated ( is displayed).

Toggle the lo button until “m” is displayed.	The unit will automatically switch to mono if
	the received signal is not strong enough for
• Press ; the frequency will change in
	stereo playback.
short intervals in upwards or down-
wards direction.

When active, “REG ON” will be briefly dis- When holding the or button down, the

played each time the radio is switched on. frequency scan is speeded up.

Changing the memory bank

You can shift between the memory banks I, II and T in order to store stations and recall

Selecting a station

With this car radio you can receive FM stati- ons from 87.5 to 108 MHz.

Using the buttons there are two different ways to tune into a station:

Selecting the seek tuning sensi- tivity

You can alter the automatic seek tuning sensitivity.

For this,

them later.

The currently selected memory bank is indi- cated in the display.

•Toggle the FM button until the desired memory bank lights up in the display.

Automatic tuning		• press the lo button briefly.	Storing stations
		If “lo” is displayed, the radio will only pick up
Prerequisite: “AF” and “m” do not light up instrong, local stations (low sensitivity).			On FM, you can store five stations on the
the display, i.e. the Alternative Frequency		If “lo” does not light up, the radio will also pick
			preset buttons 1 to 5 for each of the memory
function and manual tuning are switched off.
		up weaker, distant stations (high sensitivity).	banks I, II and T.
Use the AF and lo buttons (lo, m, -, lo) to
		Make sure that “m” is not indicated in the
			• Select the memory bank with FM.
adjust the respective modes.
• Press ; the car radio will automati-		display.	• Tune in a station either automatically or
cally search for the next station.		Switching from stereo to mono	manually.
When keeping the or the	button depres-		• Press the desired preset button until
		(FM)
sed, seek tuning will speed up in upwards or			the radio resumes play after the muting
downwards direction.		If reception is poor, you may get better sound	and you hear the beep.
		quality by switching to mono:	Now the station has been stored.
		• Press the lo button until a beep sound	The activated preset button is indicated in the
		is released and the stereo sign dis-	display.

appears from the display.

20