General settings — PSM
You can change PSM (Preferred Setting Mode) items listed in the table that follows.
1
2Select a PSM item.
3Adjust the PSM item selected.
4Repeat steps 2 and 3 to adjust other PSM items if necessary.
5Finish the procedure.
ENGLISH
Indications | Selectable settings, [reference page] | ||
DEMO | DEMO ON : | [Initial]; Display demonstration will be activated automatically | |
Display |
|
| if no operation is done for about 20 seconds, [5]. |
demonstration | DEMO OFF : | Cancels. | |
CLOCK H | 1 – 12, [5] |
|
|
Hour adjustment | [Initial: 1 (1:00)] | ||
CLOCK M | 00 – 59, [5] |
|
|
Minute adjustment | [Initial: 00 (1:00)] | ||
L/O MODE | When connecting an amplifier or a subwoofer, set this correctly. | ||
Line output mode | REAR | : | [Initial]; Select if the REAR LINE OUT terminals are used for |
|
|
| connecting the speakers through an external amplifier. |
| WOOFER | : | Select if the REAR LINE OUT terminals are used for |
|
|
| connecting a subwoofer. |
AMP GAIN | You can change the maximum volume level of this unit. | ||
Amplifier gain | LOW PWR : | VOL 00 – VOL 30 (Select this if the maximum power of the | |
control |
|
| speaker is less than 50 W to avoid damaging the speaker.) |
| HIGH PWR : [Initial]; VOL 00 – VOL 50 | ||
9