ENGLISH
Manual preset
You can preset up to 6 stations in each band (FM1, FM2, FM3, and AM) manually.
Ex.: Storing FM station of 92.5 MHz into the preset number 1 of the FM1 band.
1 Select the band (FM1 – 3, AM) you want to store stations into (in this example, FM1).
Each time you press the
button, the band changes as follows:
4 Repeat the above procedure to store other stations into other preset numbers.
Notes:
•A previously preset station is erased when a new station is stored in the same preset number.
•Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.
FM1 
FM2 
FM3 
AM
2 Tune in to a station (in this example, of 92.5 MHz).
To tune in to stations of higher frequencies
To tune in to stations of lower frequencies
3 Press and hold the number button (in this example, 1) for more than 2 seconds.
Preset number flashes for a while.
Tuning in to a preset station
You can easily tune in to a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on pages 11 and 12.
1 Select the band (FM1 – 3, AM).
Each time you press the
button, the band changes as
follows:
FM1 
FM2 
FM3 
AM
2 Select the number (1 – 6) for the preset station you want.
Note:
You can also use the 5 (up) or ∞(down) button on the unit to select the next or previous preset stations. Each time you press the 5(up) or ∞(down) button, the next or previous preset station is tuned in.
12