English
Troubleshooting Guide
What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems.
PROBLEM |
| POSSIBLE CAUSE | SOLUTION |
|
|
|
|
The power does not turn on. |
| The fuse has blown. | After checking for short circuits in the cables, replace |
|
|
| the fuse with one having the same rating. |
|
|
|
|
|
| No ACC position on vehicle ignition. | Connect the same cable to the ignition as the battery cable. |
|
|
|
|
If you have selected Standby |
| The Power Off Timer function has been activated. | If you do not want the power to go OFF automatically, |
mode, the power will go OFF |
|
| cancel the Power Off Timer function. |
automatically. |
|
|
|
Nothing happens when the |
| The computer chip in the unit is not functioning normally. | Press the reset button on the unit (see page 4). |
buttons are pressed. |
|
|
|
|
|
|
|
Radio reception is poor. |
| The car antenna is not extended. | Pull out the antenna all the way. |
|
|
|
|
|
| The antenna control cable is not connected. | Connect the cable correctly, referring to the section on |
|
|
| "Connecting Cables to Terminals". |
|
|
|
|
The memory is erased when |
| The battery cable has not been connected to the proper | Connect the cable correctly, referring to the section on |
the ignition is turned off. |
| terminal. | "Connecting Cables to Terminals". |
|
|
|
|
|
| The ignition and battery cable are incorrectly connected. | Connect the cable correctly, referring to the section on |
|
|
| "Connecting Cables to Terminals". |
The TEL mute function does |
| The TEL mute cable is not connected properly. | Connect the cable correctly, referring to the section on |
not work. |
|
| "Connecting Cables to Terminals". |
|
|
|
|
The TEL mute function turns |
| The TEL mute cable is touching a metal part of the car. | Pull the TEL mute cable away from the metal part of |
on even though the TEL mute |
|
| the car. |
cable is not connected. |
|
|
|
|
|
|
|
Free switching of the sound |
| The system Q function is set on Scan mode. | Refer to the “System Q” page and switch it to a |
quality. |
|
| function other than Scan mode. (see p. 7). |
|
|
|
|
Audio control setting cannot be |
| The system Q function is set on Scan mode. | Refer to the “System Q” page and switch it to a |
achieved. |
|
| function other than Scan mode.(see p. 7). |
|
|
|
|
— 38 —