Getting started
Canceling the display demonstration
The display demonstration is always turned on unless you cancel it.
When you turn on the power (or after you reset the unit), the display shows:
[CANCEL DEMO] \ [PRESS] \
[VOLUME KNOB]
1Press the volume knob.
[YES] is selected as the initial setup.
2Press the volume knob again to confirm. [DEMO OFF] appears.
If no operation is done for about
15 seconds or if you turn the volume knob to select [NO] in step 2, [DEMO MODE] appears and the display demonstration starts.
Setting the demonstration mode
1Press the volume knob to enter [FUNCTION].
2Turn the volume knob to select [DEMO MODE], then press to enter
3Turn the volume knob to select [ON] or [OFF].
If [ON] is selected, display demonstration starts if no operation is done for about 20 seconds.
4Hold 
to finish the procedure.
Adjusting the clock
1Press the volume knob to enter [FUNCTION] mode.
2Turn the volume knob to select [SETTINGS], then press to enter.
3Turn the volume knob to select [CLOCK], then press to enter.
4Turn the volume knob to select [CLOCK ADJ], then press to enter. Clock ho r flashes on the display.
5Turn the volume knob to adjust the hour, then press to enter minute adjust ent.
Clock inutes flashes on the display.
6Turn the volume knob to adjust the minute, then press to confirm.
Press 4 / ¢ to move between the hour and minute adjustment.
7 Hold 
to finish the procedure.
Listening to the radio
Hold to turn on or off the Traffic Information function (not applicable if “MW/ LW” is selected).
| Hold for about 2 seconds to memorize the current station or the selected Program | ||
| Type. (Refer to [PTY SEARCH] on page 7 to select the Program Type.) | ||
|
|
| Press briefly to recall memorized station (or Program Type after entering the PTY |
|
|
| |
|
|
| |
|
|
| search mode). |
6 |
|
| Autogood products Internet store “130” |