Functions of controls, General operations

Functions of controls

General operations

Power button

Press any button to switch the unit on. The display will show a message “WELCOME. Press and hold the POWER button to switch the unit off. The display will show a message “GOOD-BYE.

Note: After the unit is off, volume level and radio current settings will be memorized, and when you turn the unit on it will resume the stored status you set.

Volume control

Rotate the VOL knob (VOL knob / SEL button) on the faceplate. The larger the number shown on the display, the higher the volume level.

Audio settings adjustment

Press the SEL button (VOL knob) until the display shows: BAS 0 => TRE 0 => BAL R-L => FAD. Rotate the VOL knob to adjust each mode.

-BASS/TREBLE: -7, -6, -5,......, 0, +1, +2,......+5, +6, +7

-BALANCE: 7L, 11L,......, L=R, 1R,......,7R

-FADER: 7R, 11R,......, R=F, 1F,......, 7F

NOTE: Adjustments to Bass and Treble will override any preset EQ (Preset Equalizer Curves).

In each mode, the waiting time is about 5 seconds, and the waiting time is over, it returns to the last display mode of radio or disc playback mode.

Mode selection

Press the TUNING knob to cycle the Play mode: AUX => RADIO => DISK => USB => CARD.

NOTE: USB, CARD, DISK mode will only show on the display when a USB flash memory is inserted into the USB port.

Loudness control

Press the VOLUME knob / SEL button until “LOUD OFF is shown. Turn the volume knob to select between ON or OFF.