Sound Setting
SOURCE/POWER
Rotary encoder |
| BAND MENU | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
MODE
Adjusting Bass/Treble/Balance (Between
Left and Right)/Fader (Between Front
and Rear)/Defeat
1Press MODE repeatedly to choose the desired mode.
Each press changes the mode as follows:
BASS 
TREBLE 
SUBW* 
BALANCE 
FADER 
DEFEAT 
VOLUME 
BASS
Bass level:
Treble level:
Subwoofer : 0 ~ +15
Balance : L15 ~ R15
Fader : R15 ~ F15
Defeat : ON/OFF
Volume : 0 ~ 35
•If MODE is not pressed within 5 seconds after selecting the BASS, TREBLE, BALANCE, FADER, DEFEAT or SUBW mode, the unit automatically returns to normal mode.
* When the subwoofer mode is set to OFF, its level cannot be adjusted.
2Turn the Rotary encoder until the desired sound is obtained in each mode.
By setting Defeat ON, previously adjusted settings of BASS and TREBLE will return to the factory defaults.
Setting the Bass Control
You can change the Bass Frequency emphasis to create your own tonal preference.
1Press MENU to select the BASS ENGINE mode, then press MODE.
BASS ENGINE 
SETUP 
RETURN (OFF) 
BASS ENGINE
2Press 
or 
to select the BASS (Bass Center Frequency) control mode.
BASS 
TREBLE
Setting the Bass Center Frequency
80Hz 
100Hz 
120Hz 
60Hz 
80Hz
Emphasize the displayed bass frequency ranges.
Setting the Bass Bandwidth
3-2 Press BAND to select the desired bass bandwidth.
Change the boosted bass bandwidth to wide or narrow. A wide setting will boost a wide range of frequencies above and below the center frequency. A narrower setting will boost only frequencies near the center frequency.
Setting the Bass Level
You can emphasize or weaken the bass level.
4Press MENU to select RETURN.
After 2 seconds, the unit returns to normal mode. Pressing and holding MENU for at least 2 seconds will return to normal mode.
•If no operation is performed within 60 seconds, the bass control setting will be turned off automatically.
•The bass level settings will be individually memorized for each source (FM, AM, CD, etc.) until the setting is changed. The bass frequency and bass band width settings adjusted for one source are effective for all other sources (FM, AM, CD etc.).
•This function is inoperable when DEFEAT is set to ON.
•While in the bass adjusting mode, TREBLE CONTROL adjusting
mode can be recalled by pressing 
or 
.
*1 The adjustment can also be made by pressing MODE. Refer to “Adjusting Bass/Treble/Balance (Between Left and Right)/Fader (Between Font and Rear)/Defeat” (page 12).
Bass level indicator’s display
Bass level is usually displayed