Audiovox CP-250 manual Radio Installation

RADIO INSTALLATION:

1.Remove dash panel from vehicle to expose sub-dash.

2.Remove and discard radio dummy panel attached to sub-dash. NOTE: Do not discard hardware for dummy panel.

3.Pre-wire radio including antenna wire. Attach ring lug on ground wire (black w/white stripe) from radio harness side and the vehicle side grounding strap to the rear of the radio chassis using the M5 x 8 screw provided. See Fig. 4 below.

4.Install radio into sub-dash of vehicle using the M6 x 18 self-tapping screws provided.

5.Conduct a brief performance test to verify proper operation.

6.Replace dash panel.

FIG. 4

ANTENNA WIRE

GROUNDING STRAP

M5 x 8		RADIO HARNESS
SCREW
		GROUND WIRE
	(black w/white stripe)

ADAPTOR HARNESS (supplied)

M6 x 18

SCREWS