PCR2500
INSTALLATION INSTRUCTIONS/WIRING DIAGRAM
Do You Need an Installation Kit?
Inspect the radio opening as described below to determine if you need an installation kit.
1.Use the trimplate supplied with the radio to cover the existing dashboard opening. If it completely covers the opening, you can install the radio without an installation kit. If it does not cover the opening, you will need an installation kit (see page 4).
2.Check for sufficient space behind the dashboard for the radio chassis.
Wiring the Radio
1. | Place the radio near the dashboard so the |
| wires can be led through the opening. |
2. | Carefully follow the wiring diagram, secur- |
| ing all connections with wire nuts or elec- |
| trical tape. |
3. | Turn the unit on to confirm operation (vehi- |
| cle ignition switch must be “on”). If unit |
| does not operate, check all wiring until the |
| problem is corrected, then turn unit off. |
4. | Adjust the AM Antenna Trimmer, located |
| on the right side of the chassis, for opti- |
Antenna Connector
WARNING! Never combine (bridge) outputs for use with 1 speaker.
WARNING! Never ground negative speaker leads to chassis ground.
CAUTION: Failure to wire exactly as shown may cause electrical damage.
LEFT
White/Black
White (+)
Black
Red
3A |
RIGHT
Gray/Black
Gray (+)
WIRING DIAGRAM
Ground
Connect to ground terminal.
Accessory/Ignition
Connect to existing radio wire or radio fuse.
Fuses
When replacing a fuse, make sure the new fuse is the correcttype (AGC) and amperage. Using an incorrect fuse could damage the radio.
mum AM reception. | |
a. | Tune in a weak station around 1400 |
| KHz on the AM band. |
b. | Using a small screwdriver, slowly |
| adjust the trimmer for maximum |
| output from the radio. |
NOTE: The Antenna Trimmer only affects AM reception and will have no effect on FM reception. The Trimmer should only need adjusting when the radio is first installed and when a change is made to the vehicle antenna (replacing the mast, etc.).
AM ANTENNA TRIMMER
3