CD PLAYER ERROR CODES
If a problem should develop while operating the CD player, an error code (ER-1, ER-2, ER-3, etc.) may appear on the display panel. This can indicate a number of problems with the unit, including a mechanical error or an error in the microprocessor control of the player. If an error code should appear, try ejecting and re-loading the disc into the player. While the disc is out of the unit, make sure it is clean, undamaged, and loaded correctly (label surface up). You may also try activating the RESET button dnon the unit, but this will also erase the time and pre-set memories.
If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.
CD CHANGER ERROR CODES
If a problem should develop while operating the CD changer, the following error codes may appear on the display panel.
ER-1:Indicates that there is no magazine loaded in the CD changer.
ER-2:Indicates a problem with the magazine eject function.
ER-3:Indicates an error in the disc loading function.
ER-4:Indicates an error in the disc un-loading function.
ER-5:Indicates an error in the magazine position.
ER-6:Indicates an error in the laser pick-up position.
ER-7:Indicates an error in the laser focus on the disc.
In any of the above situations, try ejecting the CD magazine from the changer and make sure the discs are clean, undamaged, and loaded correctly (refer to the Owner’s Manual of the CD changer). Re-load the magazine and check for proper operation. You may also try activating the RESET button dn on the unit, but this will also erase the time and pre-set memories.
If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.
-13-
