Cq Equalizer Selector P.EQ | Audiovox P945WESP specs

FRONT PANEL RELEASE BUTTON

cq EQUALIZER SELECTOR (P.EQ)

The P.EQ button applies preset sound effects to the unit’s audio output signal. The P.EQ button, when pressed, will activate one of the following operating modes: CLASSICS, POP M, JAZZ, FLAT,or DSP OFF. If the bass and treble levels are changed when the P.EQ function is active, as displayed on the panel, the equalizer function automatically reverts to the FLAT setting. When the equalizer function is not active, the unit returns to the user set bass and treble levels. The FLAT selection indicates no equalizer enhancement of the program, while DSP OFF inhibits

selection of equalizer mode enhancement.

cr LOCAL/DISTANT (LOC) SELECTOR

This feature is used to select the strength of the signals at which the radio will stop during Automatic Seek Tuning. Pressing and holding this button will select the Local setting (LOCAL will ap- pear on the display panel) and only strong (local) stations will be received. Pressing the button again will select the normal Dis- tant setting (Dx will appear on the display panel). The radio will now stop at a wider range of signals, including weaker (more distant) stations.

csMODE SELECTOR (MODE)

This button is used to select the radio, external (AUX) audio in- put, or the playback mode for the CD player or remote CD changer (if installed). Each press of the button will select a different mode (as indicated on the display panel.

During CD player operation, this button may be used to change to radio or remote CD changer mode (CDC) without ejecting the

disc (the indication will remain on the display panel to show that a disc is still loaded in the unit). Press the button again to return to integral CD player mode and resume play of the disc from the point at which it was stopped.

ct & cu DISC SELECT (D.UP & D.DN)

These buttons are used to increase or decrease selection of a desired disc for play in the remote CD changer. To advance to a higher number disc, press the D.UP button ct. To return to a lower number disc, press the D.DN button cu. The number of the disc in play will be shown on the display panel.

This button is used to release the mechanism that holds the front panel to the chassis. To detach the front panel, press the button so that the left side of the panel is released. Grasp the released side and pull it off of the chassis.

To re-attach the panel, position the right side of the panel in place first and then press the left side of the panel in until the mechanism locks it into place.

dm THEFT-DETERRENT LED

The theft-deterrent Light Emitting Diode (LED) is located behind the front panel and is accessible when the front panel is removed. The flashing light serves as a visual warning to the would-be thief that the unit has been disabled by removal of the front panel.

-8-

128-6862A

8 of 16