Audiovox P153B manual Setting the Clock, Malfunctions

NOTES ON USE OF FRONT PANEL

1.Make sure the front panel is oriented correctly when sliding it into the front mounting plate, as it cannot be attached when up-side down. Use moderate pressure to fully seat the panel into position.

2.To verify correct panel installation, swing the panel assembly up into position until it locks easily into place. If any resistance is encountered, re-check panel orientation in chassis mounting plate.

NOTE: When the faceplate is in the upright position, press the release button to lower the faceplate away from the radio chassis.

3.When taking the front panel with you, please use the supplied carrying case to protect the panel from dirt and damage. Make sure there is no dust or dirt on the electrical terminals on the back of the panel as this could cause intermittent operation or other

malfunctions.	FACE PLATE	FRONT PANEL	CD EJECT
	RELEASE BUTTON RELEASE BUTTON		BUTTON

MOUNTING

PLATE GUIDE (2)

PANEL MOUNTING	FRONT PANEL	CD SLOT
PLATE

SETTING THE CLOCK

1. Switch the vehicle ignition and radio “on”.

2. Press and release the Time/Frequency button to access the time display; then press and hold the T/F button until the time colon begins to flash.

3.With the time colon flashing, press the Down Tuning ( ) button to adjust the hours and AM/PM indication, or the Up Tuning ( ) button to adjust the minutes indication to the correct time.

4.Five seconds after the last hour or minute adjustment is made, the time will be set into the unit and the display will return to the normal indication.

-11-