MP6512i
CD PLAYER OPERATION
Insert CD
1.Press the OPEN/EJECT button (1) and the motorized front panel will slide down automatically to display the disc slot.
•If a disc is already present, it will be ejected. Remove the ejected disc before proceeding.
•Hold the OPEN/EJECT button for 2 seconds to open the front panel door without activating the eject function.
2.With the label surface facing up, fully insert a compact disc into the disc slot until the mechanism engages and pulls the disc in.
•After inserting a disc, the unit will pause for a few seconds and then automatically return to the closed position and begin playing the disc.
•If no disk is inserted or the faceplate is removed, the motorized chassis will close after 10 seconds.
Eject CD
Press the OPEN/EJECT button (1) and the motorized front panel will slide automatically down to display the disc slot.
The unit will automatically stop CD play and eject the disc. If the disc is not removed from the unit within 15 seconds, the disc will be reloaded to prevent accidental damage.
NOTE: The unit is designed for play of standard 5” (12 cm.) compact discs only. Do not attempt to use 3” (8 cm.) CD singles in this unit, either with or without an adaptor, as damage to the player and/or the disc may occur. Such damage will not be covered by the warranty on this product.
Pause
Press the pause >/ button (8) to suspend disc play. Press the pause >/ button again to resume disc play.
Track Select
Press the TUNE/TRACK >> or << buttons (17) for less than one second to advance to the next track on the CD. The selected track number will appear on the display. Press and hold the TUNE/TRACK >> or << buttons (17) to fast forward or fast reverse through the disc. CD play starts when the button is released.
Intro Scan (INT)
During disc play, press the INT button (9) to select “INT ON” and play the first 10 seconds of each track on the disc. When the desired track is reached, press INT again to end the scan and play the selected track.
Repeat (RPT)
Press the RPT button (10) during disc play to select “RPT ON” and continuously repeat the track. Press RPT again to stop repeating.
Random (RDM)
Press the RDM button (11) during disc play to select “RDM ON” and play all tracks on the CD in random, shuffled order. Press RDM again to stop random play.
MP6512i
UNIVERSAL SERIAL BUS
/
SAT
READY
CD Player Error Codes
If a problem should develop while operating the CD player, an error code may appear on the display panel. This can indicate a number of problems with the unit, including a mechanical error or an error in the microprocessor control. If an error code appears, try ejecting and reloading the disc into the player. While the disc is out of the unit, make sure it is clean and undamaged, and then load it correctly. If this does not solve the problem, pressing the RESET button may help, but will erase the time and preset memory. If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.
12