Overhead Dome Lights

3.(B) To tune weak or marginal channels with the CHANNEL UP/DOWN buttons , press the SKIP/SEARCH button on the Remote Control Unit until “SKIP MODE OFF” is displayed on the bottom of the screen. Tune to the desired channel using the CHANNEL UP/DOWN buttons or go directly to the channel by using the 0-9 buttons on the Remote Control.

4.To ERASE a channel, press the ERASE/WRITE button on the Remote Control Unit until “MANUAL MEMORY XX ERASE” is displayed on screen. To STORE a channel, press the button until the MANUAL MEMORY XX ADD is displayed on screen.

The Dome lights integrated into the PROVE8 are controlled by a three position slide switch. Sliding the switch to the on position will turn the lights on. The off position will prevent the lights from turning on at all times, and the auto position will allow the lights to turn on and off with the vehicle’s interior lighting. Refer to the Installation Manual for the wire connections. Do not leave the vehicle unattended with the dome light switch in the on position, as this could result in a discharged battery.

POW ER	E JECT	REV	PLAY	FW D	STO P
		AU TO	S OURCE	P ICTUR E
CH ANNEL		PR OGR AM	S ELECT	SELECT	VO LUME

ON OFF AUTO

IO	R
AUD	L

PUT
IN	O
	DE
	IV

HEADP HONE S

Dome

Light

Switch