Basic Operation
Note The faceplate bracket will automatically close after 10 seconds even though the faceplate is not detached.
When the faceplate slides down, the unit will turn on if the user presses any button except [OPEN] or [EJECT].
Attaching the Front Panel
Make sure that the faceplate bracket is in the closed position.
Press the faceplate against the front of the unit until it clicks into place.
N O T E : To protect the front panel, place it in the supplied carrying case when you leave the car
CAUTION
Do not:
Attempt to attach the faceplate to the faceplate bracket when the bracket is in the open position.
Manually force the faceplate or you may cause damage to the mechanism that could result in voiding your warranty.
This faceplate is not waterproof.
Expose it to water or excessive moisture.
Remove the faceplate while driving your car.
Place the faceplate on the dashboard or nearby areas where the temperature rises to high levels.
Touch the contacts on the face plate or on the main unit, since this may result in poor electrical contacts. If dirt or other foreign substances get on the contacts, wipe them off with a clean and dry cloth.To avoid damaging the front panel, do not push it down or place objects on it while it is open.
Initial System Start-Up (Reset)
Be sure to press the RESET switch if a fatal problem occurs with the unit or during initial installation. Remove the faceplate to push the reset switch.
Figure 1.3 Bracket & Position of Reset Switch
9