OPTICA™ 300
SHOWER MIXER/TRANSFER VALVE
INSTALLATION INSTRUCTIONS
FINISHING WALL
TILE (FINISH SURFACE)
SEALANT (SILICONE) ON BACKSIDE OF
FACEPLATE
FACEPLATE (SEALANT NOT PROVIDED)
GASKET
TRIM SLEEVE OF TRANSFER VALVE
SWEAT ADAPTOR (NOT PROVIDED) COPPER PIPE (NOT PROVIDED)
REAR VIEW
FEMALE THREAD TO SWEAT ADAPTOR (NOT PROVIDED)
SEALANT (100% SILICONE) ON BACKSIDE OF
FACEPLATE (SEALANT NOT PROVIDED)
NOTE: WHEN INSTALLING BAND, RING, ROPE
OR FACETED HANDLE, PULL TRIM SLEEVE OUT
TO MEET HANDLE.
|
|
|
|
|
|
|
|
|
| GASKET |
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| TRIM SLEEVE |
| REAR VIEW | |||||
|
|
|
|
|
|
|
|
| |||||||
|
|
|
|
| PLASTER GUARD |
| |||||||||
|
|
|
|
|
|
|
| WOOD CROSS MEMBER |
| (FRONT HAS RED | |||||
|
|
|
|
|
|
|
|
| AND BLUE DOTS) | ||||||
OPTICA 300
WARNING: This system/device must be set by the installer to ensure safe, maximum temperature. Any change in the setting may raise the discharge temperature above the limit considered safe and may lead to scalds.
CAUTION: As the installer of this valve, it is your responsibility to properly install and adjust this valve per the instructions given. This valve does not automatically adjust for inlet temperature changes, therefore, it is necessary to adjust the Rotational Limit Stop at the time of installation. You must inform the owner/user of this requirement by following the instructions below. After installation and adjustment, you must write in the temperature and the date you adjusted the Rotational Limit Stop on the warning label provided and apply or attach it to the hot water heater. Be sure this instruction sheet is delivered to the owner/user.
WARNING: This pressure balanced bath valve is designed to minimize the effects of outlet water temperature changes due to inlet pressure changes, commonly caused by dishwashers, washing machines, toilets and the like. It may not provide protection from scalding when there is a failure of other temperature controlling devices elsewhere in the plumbing system if the Rotational Limit Stop is not properly set, or if the hot water temperature is changed after the Rotational Limit Stop is set, or if the water inlet temperature changes due to seasonal changes.
INSTALLER: LEAVE THIS INSTRUCTION MANUAL FOR OWNER'S/USER'S REFERENCE
©1995 Jacuzzi Whirlpool Bath G570000 D 12/06 | Page 1 |