
SETTING THE CLOCK
1.) Switch the unit to Standby mode by pressing the STANDBY/ON
button.
2.) Press and hold the MEMORY/CLOCK button. “ 24 H ” (24 Hour format) will flash
in the display. Press the ![]()
or ![]()
![]()
button to select “ 12 H ” (12 Hour format).
3.) Press the | MEMORY/CLOCK button. The hour digit will flash. |
Press the | or buttons to set the correct hour. Be sure to set correctly for |
AM or PM.
4.) Press the MEMORY/CLOCK button again. The Hour is now set and the Minute digits start to flash in the display.
5.) Press the ![]()
or ![]()
![]()
buttons to set the correct minute.
6.) Press the MEMORY/CLOCK button again. The Minutes are now set and the clock will start to run.
NOTE:
•Clock time is only retained while the unit is plugged into the AC outlet. In the event of a power failure the clock will need to be reset when the power supply resumes.
•Clock time is only shown when unit is in Standby mode.
13
ES58_012904.p65 | 13 |
29/1/2004, 15:24