Garmin PAV80 Section III Operation, Operating Controls, Power/Volume Control, Stop/Eject Button

Page 17

PS Engineering

PAV80

Installation and Operator’s Manual

Section III OPERATION

GENERAL INFORMATION

3.1SCOPE

This section describes the operation of the PAV80 In-Flight Entertainment system. Operating controls consist of two rotary knobs with push-push switches, and four buttons.

Figure 3-1 Front Panel Controls

3.2Operating Controls

The single-disk player is designed for simple operation. The Disc player will begin to play automatically when a MUSIC Disc is inserted. The disc will play through in order, and then stop at the end.

If a DVD is inserted, the unit will wait for menu instructions.

3.2.1Power/Volume Control (1)

The PAV80 system is turned on and off by pushing the volume (left hand) knob. A short press will acti- vate, and deactivate the unit.

The left knob is also the volume control, with 30 steps. The knob controls the volume of the primary out- put. To modify the volume of the SECONDARY output, press the volume knob for more than 2 seconds. The secondary output indication (right side of window) will blink, and you can now adjust the secondary output volume.

If the knob is not active for more than 5 seconds, the volume control reverts to the primary state.

The four push buttons are used to perform different functions. The function will depend on the mode of the primary audio output, as displayed on the left side of the display (P).

3.2.2 Stop/Eject Button (2)

In disc mode, the Stop/Eject button will stop the disc. Hold for 3 seconds to eject the disc. In AM/FM mode, this will scan up to the next strong radio station.

3.2.3 Play/Pause Button (3)

In disc mode, pressing the play/pause button momentarily will pause the player. Press again to resume play.

In AM/FM mode, this will scan down to the next strong radio station.

200-800-0101

Page 3-1

Rev. 5 Feb. 2004

Image 17
Contents PS Engineering, Inc RevisionEquipment Required but not Supplied Appendix E Rtca DO160D/EUROCAE ED-14D Environmental Introduction Section I General InformationScope Equipment DescriptionFAA-PMA Compliance SpecificationsEquipment Supplied FAA-TSO ComplianceEquipment Required but not Supplied PVA802 Installation KitOptional Equipment License Requirements Approved Audio SystemsEquipment Installation Procedures Section II InstallationGeneral Information Unpacking and Preliminary InspectionFactory Avionics Location Mounting Rack InstallationPanel Opening Connector AssemblyNoise Cable Harness WiringAntenna PowerBacklighting Unit Installation Aux Entertainment Audio and AUX EnablePVT801 Display Installation Optional PVA802 Video Distribution Amplifier InstallationSystem Checkout Internal AdjustmentsPost Installation Checkout Final Inspection FM/COM Cross ReferenceSection III Operation Power/Volume ControlOperating Controls Stop/Eject ButtonButton Mode KnobDisplay Operation Data knob PushRemote Operation N UDisplay Dimming Factory Service Section IV- Warranty and ServiceWarranty Creating MP3s from an Audio CD Appendix a MP3 CreationNew Installation Side Connector Key Display connector layout PVT801 Mounting Tray Dimensions if used Circuit breaker installation drawing 120-800-8802 typical 470 Single Display System Appendix C Connector InterconnectPVT801Video Terminal#4 Multiple Display System WiringInstructions for Continuing Airworthiness, PAV80s Instructions for FAA Form 337, PAV80sTitle This manual Part Number Revision Date Master Drawing ListAppendix D Rev , Feb Conditions Section Conducted Tests