Performance Teknique ICBM-1-TOUCH manual Basic Operations, SRC Functions

Page 10

Basic Operations

SRC Functions

The machine is on once the playing source has been selected Press this key

to switch between the following playing sources:

1.AUX

Select Auxiliary Input

2.CDC

Select Disk Input

3.TUNER

Select Radio, and radio menu will be displayed

4.TV

Select TV Input

5.DVD

Select DVD Input

6.EXIT

Exit, Close the System

The playing sources can be selected through touching directly, and the system will enter the highlighted item if there is no selection after 2 seconds.

Turn Off the Machine:

Long-press SRC key,OFF will appear and the system closed.

Press SRC, touch menu will appear, select EXIT.

Switch off ACC power source.

Precautions

The monitor will retract automatically to the minimum angel. The machine will retract automatically and close 5 seconds later if the power switch is turned from ON to OFF.

When the power switch is turned to ON or ACC again, the system will reset automatically and rebound to its previous status. When the system is turned off, pls make sure all the panels are closed. If the closing of the monitor stops for some obstacle and nothing is done to change it, damage may occur.

Volume Adjusting

1.Use the Volume key on the host panel. 2.Touch the volume adjusting area

3.Use the Volume key on the remote controller

Basic Operations:

Adjust the Monitor Angel:

Press ANG key on the monitor panel, the monitor will move within the minimum and maximum angels, until the key is let off.

If it is a short press, the monitor will be slightly adjusted following its original direction.

Touch the angel adjusting area on the monitor panel, area (4) is to increase the angel, and area (8) is to decrease.

Precautions:

While adjusting the angel of the monitor panel, press ANG key or touch the angel adjusting area. Do not move or press the monitor by hand, or serious damage may occur.

Playing DVD:

Press SRC to select DVD, insert valid disk in the disk box.

Insert valid disk in the disk box directly. When the DVD playing

menu appear, press PLAY (or SET) key, the system will play the disk

automatically. If you want to exit, press EJECT.

Precautions:

The system can play one 12cm or 8cm DVD disk (single-sided)

Please do not use adapters while playing 8cm disks.

Do not insert anything except disks in the disk box.

If you can't insert a while disk, or it cannot be played, please check

whether the label side is upward. Press EJECT to take out the disk to see

whether there is any damage before inserting it again.

If DVD indicator displays RED, it means there is no disk in the box.

If it is blue, it means there is a disk. Do not insert diskforcefully in

this situation, so as not to harm the interior devices..

1516

Image 10
Contents Operating Instructions Contents Matters to Note DVD Region CodeUse and Maintenance of Remote Control Reset the micro-processorConnection Instructions CDCÊäÈëTouch Key Functions Touch Key Functions Touch Key 1 SRCVedio sourceFunction Key15 + Key System MenuKey Functions Ï Â Ê Ç Ã æ å ´ ¼ ü ¹ Ä Ü Ë µ à ÷Keys on Remote Controller PowerBasic Operations SRC FunctionsTuner Listen to the RadioPress Goto once,the following will be displayed DVD PlayingDVD Function Operations Title 01 / 02 Chapter 008Main Page of DVD Setup DVD SetupGeneral Setup Audio Setup Speaker SetupInitial Setup TV½ÓÊÕ Ë ü ¹ Ä Ü 0808Problems Possible reasons Measures advices Malfunction EliminatingMaintenance of DVD Supplementary InformationMP3 Supplementary¸ ½ ¼ Ó × ÊInformationÑ ¶Information about Touching Screen