Contents | Connections | Playback | Settings | Tips | Appendix |
|
|
|
|
|
|
Remembering remote control codes from other devices
1Place the Marantz remote control and remote control from the other device approximately 5 cm apart, with the remote control signal transmission sections facing each other.
2Press and hold SET until the LEARN indicator blinks.
3Press input source select buttons to select the input source.
The input source is shown in the remote control display.
6Repeat steps 4 and 5 to learn other buttons for the same input source.
7When programming of the remote control unit is completed, press SET.
The LEARN indicator turns off, and the remote control unit exits learn mode.
0There are some remote control units that cannot be programmed, or even if they can be programmed, they may not operate correctly. If this happens, use the remote control unit supplied with the AV equipment to operate it.
0If the remote control memory becomes full, “FULL” is shown on the remote control display. If you want to learn the code, you should erase other learned button.
4Select the button to be learned.
LEARN indicator lights up.
5Press and hold the button that you want to register on the other remote control until “OK” is displayed on the Marantz remote control display.
0If “NG” is shown on the remote control display, perform step 4 again.
NOTE
0The learning function is unavailable for all ZONE SELECT, SET, AVR, POWER X, VOLUME df, SMART SELECT, SOUND MODE and input source select buttons in any mode.
0If no buttons are pressed for approximately 1 minutes while in the LEARN mode, the remote control unit automatically exits from the LEARN mode.
Front panel | Display | Rear panel | 274 | Remote | Index |
