CDX-M800
Inputs | Telephone ATT control |
| terminal |
| Illumination control terminal (US, Canadian model) |
| BUS control input terminal |
| BUS audio input or AUX IN terminal |
| Antenna input terminal (US, Canadian model) |
| Aerial input terminal (AEP, UK, E model) |
Tone controls | US, Canadian model: |
| Bass ±10 dB at 62 Hz |
| Treble ±10 dB at 16 kHz |
| AEP, UK, E model: |
| Bass ±8 dB at 100 Hz |
| Treble ±8 dB at 10 kHz |
Loudness | +8 dB at 100 Hz |
| +2 dB at 10 kHz |
Power requirements | 12 V DC car battery |
| (negative ground) |
Dimensions | Approx. 178 ⋅ 50 ⋅ 186 mm |
| (7 1/8 ⋅ 2 ⋅ 7 3/8 in.) |
| (w/h/d) |
Mounting dimensions | Approx. 182 ⋅ 53 ⋅ 163 mm |
| (7 1/4 ⋅ 2 1/8 ⋅ 6 1/2 in.) |
| (w/h/d) |
Mass | Approx. 1.5 kg (2 lb. 10 oz.) |
Supplied accessories | Parts for installation and |
| connections (1 set) |
| Card remote commander |
| |
|
Note
This unit cannot be connected to a digital preamplifier or an equalizer.
Design and specifications are subject to change without notice.
SERVICE NOTES
NOTES ON HANDLING THE OPTICAL
The laser diode in the optical
During repair, pay attention to electrostatic breakdown and also use the procedure in the printed matter which is included in the repair parts.
The flexible board is easily damaged and should be handled with care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on the disc reflective surface by the objective lens in the optical pick- up block. Therefore, when checking the laser diode emission, ob- serve from more than 30 cm away from the objective lens.
Notes on Chip Component Replacement
•Never reuse a disconnected chip component.
•Notice that the minus side of a tantalum capacitor may be dam- aged by heat.
US, Canadian model:
CAUTION
Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
If the optical
Never turn the
optical
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ!!
LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE 0 SUR LES
DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES
SONT CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT.
NE REMPLACER CES COMPOSANTS QUE PAR DES PIÈCES
SONY DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL
OU DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.
2