Changing the sound and display settings

You can set: •Clock (page 5)

•D. Info (Dual Information) to display the clock and the play mode at the same time (ON), or to display the information alternately (OFF).

•Amber/Green to change the illumination color to amber or green.

•Dimmer to change the brightness of the display.

—Select “Auto” to dim the display only when you turn the lights on.

—Select “on” to dim the display. •Contrast to adjust the contrast if the indications in the display are not

recognizable because of the unit’s installed position.

•Beep to turn on or off the beeps.

•RM (Rotary Remote) to change the operative direction of the controls of the rotary remote.

—Select “norm” to use the rotary remote in the factory preset position.

—Select “rev” when you mount the rotary remote on the right side of the steering column.

•Loud (Loudness) to enjoy bass and treble even at low volume. The bass and treble will be reinforced.

•LPF (Low Pass Filter)

•A. Scrl (Auto Scroll) (page 12)

•Disc MEMO/TEXT name (Disc memo/CD- TEXT name) to set the priority display item when you connect an optional CD changer with the CD-TEXT and disc memo function.

Note

The displayed item will differ depending on the source.

1 Press (SHIFT), then press (2) (SET UP).

2 Press (2) (SET UP) repeatedly until the desired setting mode appears.

Each time you press (2) (SET UP), the item changes as follows:

Clock nD.Info nAmber/Green nDimmer n Contrast nBeep nRM nLoud nLPF n A.Scrl nDisc MEMO/TEXT name

3 Press (4) (n) to select the desired setting (for example: “on” or “off”).

For the “Contrast” setting, pressing (4) (n) makes the contrast higher, and pressing (1) (N) makes the contrast lower.

4 Press (SHIFT).

When the mode setting is complete, the normal playback mode appears.

Adjusting the frequency of the subwoofer(s)

To match the characteristics of the connected subwoofer(s), you can cut out the unwanted high and middle frequency signals entering the subwoofer(s). By setting the cut-off frequency, the subwoofer(s) will output only low frequency signals so you can get a clearer sound image.

1 Press (SOURCE) to select a source (radio, tape, CD, or MD).

2 Press (SHIFT), then press (2) (SET UP) repeatedlly until “LPF” appears.

3 Press (4) (n) or (1) (N) repeatedly to select desired setting.

Set

SUR EQ	LPF12âHz

Each time you press (4) (n) or (1) (N), the cut-off frequency in the display changes as follows:

LPF 120 Hz Ò Ó LPF 80 Hz Ò Ó LPF off

4 Press (SHIFT).

When the frequency setting is complete, the display goes back to the normal playback mode.

Other Functions