(if this is necessary on your system) even if you are making a local call. The number will be displayed.
CTo correct a mistake, press CLR to delete the last digit, or press and hold CLR to clear the whole display (then
DPress SEND. The IN USE indicator will appear on the display, and the number will disappear.
ETo end the call, press END.
Notes:
If NO SVC is displayed:
You are outside the cellular service area.
If NOT ALLOWED is displayed:
The call is not allowed or your phone is locked. (Refer to ‘Call restrict (Menu 14)’, page 43 and ‘Lock phone (Menu 0)’, page 34).
If the signal is poor:
The quality of your call depends on the signal strength | |||
of the cellular signal in your |
|
| |
area. The signal strength |
|
| |
indicator on the display (‘S‘ in |
|
| |
diagram right) shows received | S | B | |
signal strength. The more bars | |||
ON | SERV | ||
showing, the stronger the signal.
If the signal is poor, try moving to a different position. If you are using the phone in a building, you may find that reception is better near a window.
To adjust the earpiece volume:
On the side of the phone, press Δ to increase the vol- ume (maximum level is 5) or ∇ to decrease the volume (minimum level is 1). The volume level you select is displayed. If you try to adjust the volume below level 1, or above level 5, the phone gives a warning beep.
If you are using the handsfree option, the handsfree volume is adjusted. The volume levels for the phone, and handsfree option, are stored independently.
12