![](/images/new-backgrounds/1017164/1716449x1.webp)
MZ-G750/R700
This set LCD display |
|
0D61A1 | 0 23 |
A1: Adjusted value
25.Press the X key.
(0D61 is blinking)
26.Press the [VOL+] key once to change the blinking portion to 0D62.
This set LCD display
0D6200 | 0 23 |
00: Adjusted value
27.Press the x key.
(00 is blinking)
28.Adjust with the [VOL+] key (adjusted value up) or
This set LCD display
0D6204 | 0 23 |
04: Adjusted value
29.Press the X key.
(0D62 is blinking)
30.Press the [VOL+] key once to change the blinking portion to 0D65.
This set LCD display
0D6500 | 0 23 |
00: Adjusted value
31.Press the x key.
(00 is blinking)
32.Adjust with the [VOL+] key (adjusted value up) or
This set LCD display
0D6520 | 0 23 |
20: Adjusted value
33.Press the X key.
(0D65 is blinking)
34.Press the [T MARK] key for several seconds (about 3 seconds) to exit the patch data write mode (to return to the manual mode display in the test mode).
This set LCD display
Patch 01 | 0 23 |
01: Adjusted value
35.Press the X key to write the modified data. (The adjusted value changes to CC)
36.The modified data writing is over, if the adjusted value changes to DD.
This set LCD display |
|
SDD | 0 23 |
DD: Adjusted value
37. Turn the power off.
• Modified Data Writing Method (version 1.100)
1.Select the manual mode of the test mode, and set item number 023 (see page 13).
This set LCD display
Patch 00 | 0 23 |
00: Adjusted value
2.Press the [VOL+] key once to change the adjusted value to 01.
3.Press the [T MARK] key for several seconds (about 3 seconds) to activate the patch data write mode.
(The following display will appear where 00 is blinking)
This set LCD display |
|
0D5C00 | 0 23 |
00: Adjusted value
4.Press the X key. (0D5C is blinking)
5.Press the [VOL+] key once to change the blinking portion to 0D5D.
This set LCD display
0D5D00 | 0 23 |
00: Adjusted value
6.Press the x key.
(00 is blinking)
7.Adjust with the [VOL+] key (adjusted value up) or
This set LCD display
0D5DAA | 0 23 |
AA: Adjusted value
8.Press the X key. (0D5D is blinking)
9.Press the [VOL+] key once to change the blinking portion to 0D5E.
This set LCD display
0D5E00 | 0 23 |
00: Adjusted value
10.Press the x key.
(00 is blinking)
11.Adjust with the [VOL+] key (adjusted value up) or
25