7.Turn the engine ignition key (Figure 17) to the START position and hold it until the engine starts.When engine starts, release the key, allowing it to return to the ON position.
F | F |
|
O | O | |
|
| |
|
| N |
S
T
A
TR
Figure 17. Engine Ignition Key
8.If the choke lever was moved to the "CLOSED" position to start the engine gradually move it to the "OPEN" position (Figure 18) as the engine warms up. If the engine has not started repeat steps 1 through 6.
startup
Stopping the Engine
Normal Shutdown
1.Move the throttle lever to the IDLE position (Figure 20) and run the engine for three minutes at low speed.
Figure 20. Throttle Lever (Idle)
2.After the engine cools, push the Start/Stop switch on the engine cover inward to the “OFF” position (Figure 21).
START/STOP
SWITCH
PUSH IN
TO STOP
Figure 18. Choke Lever (Open)
9.Before the mixer is placed in to operation, run the engine for several minutes. Check for fuel leaks, and noises that would associate with a lose component.
10.To begin mixing, place the throttle lever (Figure 19) in the “RUN” position.
Figure 19. Throttle Lever (Run)
Figure 21. Start/Stop Switch (OFF Position)
3.Place the fuel
Figure 22. Fuel Valve Lever (OFF)
Emergency Shutdown
1.Move the throttle lever quickly to the IDLE position, and place the engine ON/OFF switch in the OFF position.
Pro12 hydraulic mixer • operation manual — rev. #0 (05/06/13) — page 21