Philips SE735 manual Remote control access, Activate/Deactivate remote access

EN Telephone Answering Machine (TAM)

2.Scroll :to your desired ring delay setting (1 to 7 rings or Toll saver) and press mSELECT to confirm.

Toll saver mode can save you the cost of a long-distance call when you check your messages remotely. If there are new messages in your answering machine, the outgoing message will start playing after 3 rings. If there are no new messages, the outgoing message will be played after 5 rings. Hence, if you want to check if you have any messages without incurring call charges, you can hang up the call after the 4th ring.

Remote control access

This feature lets you check your messages, or otherwise operate your answering machine, by calling the answering machine and entering a remote access code (which is the same as your Master PIN code) on a tone dialling phone. To prevent unauthorised access to your answering machine, your Master PIN code must be changed (see page 53).

Activate/Deactivate remote access

1.Press mMENU, scroll : to Answer Machine and press mSELECT, scroll : to Ans. Settings and

press mSELECT, scroll :to Remote access and press mSELECT.

2.The current selected option is highlighted.

3.Scroll :to Activated or Deactivated and press mSELECT to confirm.

Remote access code is to prevent unauthorised access of the answering machine from external callers. The remote access code is the same as the Master PIN of the phone. Your Master PIN code must be changed (see page 53) before you can access this feature.

Controlling the answering machine from an external call

1.From your external phone, dial home. The answering machine answers and starts playing your greeting message. Within 8 seconds, press # key.

2.Enter the remote access code (same as your Master PIN code). If the code is not correct, an error tone will be emitted. After the error tone is emitted, you can try to press the remote access code again until you enter the correct number.

The answer machine will drop the line immediately if there is no detection of the master PIN entry within

8seconds.

3.If the access code is correct, a validation tone can be heard. If there are new messages, all the new messages will be played immediately and then stop when there are no more new messages.

If there are no new messages, the answering machine will not play any messages.

The following table indicates how to access the below features during remote access procedure:

1	Replay current message or go to previous message.
2	Play old messages or stop them.
3	Go to next message.

64