Magnavox TB600MG2F Installing the Batteries in the Remote Control, Using the Remote Control

Page 7

ɶInstalling the Batteries in the Remote Control

Install 2 AAA (1.5V) batteries matching the polarity indicated inside the battery compartment of the remote control.

CCaution

Incorrect use of batteries can result in hazards, such as leakage and bursting. Please observe the following:

Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.

Do not mix new and old batteries together.

Do not use different kinds of batteries together. Although they may look similar, different batteries may have different voltages.

Make sure that the + and - ends of each battery match the indications in the battery compartment.

Remove batteries from the battery compartment when the remote is not going to be used for a month or more.

When disposing of used batteries, please comply with governmental regulations or environmental public rules that apply in your country or area.

Do not recharge non-rechargeable batteries.

Do not short-circuit, heat or burn any batteries.

ɶUsing the Remote Control

Remote Control Usage Guidelines:

To check remote operation, aim the remote at the unit then press any arrow button. The Standby/on Indicator on the unit will turn Off when the button is pressed and turn On again when the button is released. This confirms that the unit is receiving the IR remote signal.

Make sure that there are no obstacles between the remote control and the infrared sensor window on the unit.

Do not mount the device on the wall behind the TV as this would block the infrared sensor window from the remote infrared signal.

Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the infrared sensor window of the unit.

Remote controls of different devices can interfere with each other. Avoid using a remote control of another device which is located close to the unit.

Replace the batteries when you notice a fall-off in the operating range of the remote control.

The maximum operable ranges from the unit are as follows.

Line of sight

: approx.

23 feet (7 m)

 

 

 

 

Either side

: approx.

16 feet (5 m) within 30°

 

 

 

 

of the center

 

 

 

 

 

 

Above

: approx.

16 feet (5 m) within 15°

 

 

 

 

Below

: approx.

10 feet (3 m) within 30°

30˚

30˚

30˚

30˚

 

 

 

 

 

EN-7

EN

Image 7
Contents TB600MG2F HD Streaming Player with Built-in WiFiContents Features FeaturesNetflix ESN Product InfoTop / Front Panel Functional OverviewRear Panel Remote Control Using the Remote Control Installing the Batteries in the Remote ControlGuide to On-Screen Display Setup MenuHome Menu Hdmi Video / Audio Connection ConnectionsStandard Video + Standard Audio Connection Hdmi Audio Out Connection to an Audio SystemChannel Analog Audio Connection Hdmi Audio ConnectionConnection to the Network Wired ConnectionWireless Connection Beforeyou Start Initial SetupFinding the Viewing Video Source Input on Your TV Preparation for Network Features Using Network FeaturesInformation on Network Services Menus / Options List of SettingsOSS Network Connection SetupsWired Auto WiredManual Wired Network List Wireless WirelessAbcde Manual WirelessPIN Code Method Router PIN Easy ConnectPush Button Method PIN Code Method Netbox PINOne Touch Standby Hdmi Video ResolutionFun-Link Hdmi CEC One Touch PlayCopyright protection system Software UpdateInitialize Network UpdateProblem Tip TroubleshootingUnit is receiving the IR remote signal Problem Tip General SpecificationsNetwork Service Disclaimer To Avoid the Hazards of Electrical Shock and Fire Safety InstructionsLocation and Handling IR Signal Check MaintenanceSupplied Accessories Cleaning the CabinetInstalling on a wall Installing on a Wall or ShelfInstalling on a shelf Trademark Information Powered by Adobe FlashGlossary Pillarbox Subnet MaskMando a Distancia EspañolNota Instalación Inicial Encontrar la Entrada de Fuente de Video en su TVFunai Service Corporation