NEC 241716 manual To show where you can be reached

Location Status Information - User Guide

To Set Location Information (Continued)

The LCD displays:	What you do:	When an error message
		is displayed:
Enter Date–MMDD	To give the date on which you’ll	Out of Range=The month must
	return:	lie between 01 and 12. The day
	Enter a two-digit month.	must lie between 01 and 31,
	Months 1 through 9 should be	depending upon the number of
	entered “01” through “09”.	days in the designated month.
	Then enter a two-digit day.	Enter “#” to display the prompt
	Follow the entry with “#”.	again, or press the LSI key to end
		the session.
	To pass over this prompt without
	entering a date:
	Enter “#”.
	To default to today’s date:
	Enter “0#”.
Enter Time–HHMM	To give the time at which you’ll	Invalid Time=The time must lie
	return:	between 0001 (12:01 a.m.) and
	Enter the hour and minute on a	2400 (12:00 midnight). Enter “#”
	2400 clock, followed by a “#”.	to display the prompt again or
	(For instance, 9:00 a.m. is	press the LSI key to end the
	entered as 0900, and 2:30 p.m.	session.
	is entered as 1430.)
	To pass over this prompt without
	entering a time:
	Enter “#”.
Enter Phone No	To show where you can be reached
	until you return:
	Enter the complete telephone
	number followed by a “#”.
	(Note: This number must
	include all digits that are to be
	dialed, including access code
	and area code, and may be as
	long as 22 digits.)
	To pass over this prompt without
	entering a time:
	Enter “#”.
Message Set	To end the session and clear the
	display:
	Enter “#”.
	If no action is taken, LSI
	automatically ends the session
	and clears the display.

NDA-30044 Revision 2.0 Page 3