Listen Technologies LA-318 manual Place units in charging slots

LA-311/325 Charging Instructions (cont.)

5 Place units in charging slots.

It may be necessary to press the units down into the pocket to ensure that it is touching the charging contacts.

6	Verify units are charging.
	Watch units for 10 seconds before leaving them to charge. Once placed in the
	charging slots, the red LED on top of Listen’s portable receivers and transmitters will
	glow continuously for 1-2 seconds, then extinguish. The units will then evaluate
	battery status for 5-7 seconds. If the battery select switch is positioned in the NiMH
	setting, the red LED will begin to flash indicating that the units are charging.
	NOTE: If batteries are completely discharged, the red LED will remain solid while the
	batteries are reconditioned. Unit should begin flashing after 5-10 minutes. The
	LED may flicker during the reconditioning process.

7	Verify Full Charge.
	Each unit’s red LED will stop flashing once charging is complete. Charging time for
	full recharge on completely discharged batteries is 13 hours.
	NOTE: If a unit is removed from the case during the charge cycle, and then
	reinserted, it will begin a new charge cycle.
	WARNING: The case lid MUST be open or removed while the units are charging. The
	charging process generates heat and ventilation is required. It is best to
	store your charging case at room temperature away from heat sources
	and direct sunlight.

16-Unit Cases

19