Applications
Infrared
If you try to send data that cannot be forwarded or saved, an error message will be displayed.
Applications
Infrared
By using the infrared connection with another X200 or with other devices with an infrared port, you can transfer data between the devices.
Preparing for infrared connection
¾Place the X200 and another device with an infrared port within the effective infrared connection range of each other.
¾There must be no obstruction between the two communicating devices. ¾The infrared ports of both devices must point at each other.
¾If you use a PC, you need to set up an infrared connection on the PC.
(Example: Start > Settings > Control Panel > Infrared > Options tab > Enable Infrared Communication)
Sending data
The types of data you can send are: Contacts, Pictures and Sounds in My Stuff. Ensure that the infrared ports of your X200 and the second phone or device are pointing at each other with no obstructions in between.
Some downloaded files may be protected under copyright laws. These files should not be sent.
Setting infrared
You need to activate infrared before receiving data.
From Infrared menu 4On or Off </ A
NOTE When infrared is set to on, “ 
” appears on the display. If infrared is unused for 10 minutes or the phone is once switched off, it is automatically set to off and “ 
” disappears.
Sending pictures and sounds
From Idle display
1<
20My Stuff </ A
34Pictures or Sounds </ A
4 4required item </ A
5 4select data to send A
64Send by infrared </ A
75