H2O Audio D2-1C1, DV-i700 instruction manual To Open, To Close

Page 12

TO OPEN

STEP 5: PUSH UP

STEP 6: SLIDE OUT

STEP 7: Insert a NEW & DRY 9-Volt Alkaline battery.

CAUTION: Visually inspect the inside to make sure it is dry.

TO CLOSE

STEP 8: SLIDE IN

STEP 9: PUSH DOWN

STEP 10: SNAP CLOSE

STEP 11: Insert and connect the MP3 Player

STEP 12: Turn on the Amplifier using the external button. The LED will turn on.

WARNING: THE MP3 PLAYER VOLUME MUST BE

SET TO ZERO BEFORE TURNING ON THE

AMPLIFIER.

Image 12

Contents H2O AudioTM Introduction FCC CertificationImportant Warning HOW to Listen to the H2O Audio DV Leak TestRing Preparation General Storage Procedures Soak in clean fresh water for 30 minutesHousing Operations NavigationButton Amplifier Power ON/OFF Installing & Replacing Amplifier Battery Installing the MP3 Player Close the LID To Open To CloseRemoving the MP3 Player Installing the Stereo Jack Speaker Maskamplifierstrapoperationsoperation Removable Mask Strap ClipREMOVING/REPLACING the Speaker Clip Limited Warranty Coverage Warranty LimitationsReturning for Service Warranty CorrespondenceContacting Customer Support