STEP 2: PULL APART
STEP 1: PUSH TOGETHER
STEP 2: TIGHTEN THE SCREW
REMOVING/REPLACING THE SPEAKER CLIP:
CAUTION: Make sure that you are holding the mask on your face when entering the water. The speakers may try to pull the mask off the face when entering the water, so pay special attention to keeping the mask on your face.
STEP 1: UNSCREW
To remove the clip from the speaker:
1.Make sure the unit is turned off.
2.Hold the speaker face down.
3.With a Phillips head screwdriver, gently unscrew the clip from the speaker
4.Make sure to save the screw and clip in a safe place.
Do not lose them.
To replace the clip onto the speaker:
1.Make sure the unit is turned off
2.Hold the speaker face down.
3.Slide the clip so that it snaps into the bottom grooves first.
4. Then fit the screw through the hole.
5. Gently tighten the screw using a Phillips head screwdriver.