Numark Industries PRO TT-2 owner manual Tone ARM Settings LCD Display

PRO TT-2 Turntable

TONE ARM SETTINGS LCD DISPLAY

The following explains proper counterweight and anti-skating set up. Cartridge manufacturers usually specify the proper settings.

a)Remove the stylus protector, do not touch the stylus tip during the adjustment.

b)Set the cueing lever to the lower position so it does not effect tone arm height.

c)Set Anti-skate adjustment to 0.

d)Place counterweight on the rear of the tone arm

e)Release the arm clamp and lift the tonearm from the arm rest so it moves freely.

f)Rotate the counterweight until the tonearm is approximately balanced horizontally (floats freely).

g)Refasten the tonearm with the arm clamp.

h)Hold the counterweight stationary with one hand and rotate only the stylus-pressure ring to bring the number "O" of the

ring into alignment with the center line on the tonearm rear shaft.

i)Rotate the counterweight with scale ring clockwise to the

correct stylus pressure following the manufacturer's recommendation.

Note: Failure to follow recommended stylus pressure could damage both the stylus and record. This can also seriously degrade performance.

j)Set the anti-skating control knob to the same value as the stylus pressure, unless your manufacturer specifies otherwise.

32

31 33

29
		30
29. Speed Indication
33	- 33 rpm
45	- 45 rpm
33 + 45	- 78 rpm

30.Speed Adjust Indication - This will display adjustments in platter speed made by the pitch control.

31.Play/Pause - Indicates current state of the platter

32.Pitch/Quartz - Indicates current mode of operation

33.Platter Wheel - Simulates all actions of speed and direction of the platter.

- The Leader in DJ Technology

©2000Industries - 8 - http://www.numark.com